Install Example Image On Emmc; Overview - Siemens SIMATIC IOT Operating Instructions Manual

Software and commissioning

4.2 Install example image on eMMC

4.2 Install example image on eMMC
4.2.1

Overview

This chapter describes how to install the example image on the eMMC of the IOT2050.
Note
As IOT2050 doesn't have eMMC, this procedure is not applicable for IOT2050 Basic (6ES7647-
0BA00-0YA2).
Procedure
The installation includes the following procedures:
1. Use engineering station to flash the example image to the first USB flash drive or SD card
using, for example, Win32DiskImager.
2. Power on IOT2050 (Page 31).
3. Install the example image on eMMC of the IOT2050 in one of the following two ways:
– Use a single USB flash drive / SD card
– Use two different USB flash drives / SD card
Required Hardware
Required hardware
SD card or USB flash driver.
Engineering station
Ethernet cable
DisplayPort Cable (Male-
Male) and Monitor
Keyboard
36
- One to run the Example Image
- One to transfer the Example Image to the eMMC
Description
The internal eMMC can also be used.
To remotely access the IOT2050 and transfer files, an engineering sta-
tion is required. In this document, a PC running Windows 10 Enterprise
is used.
The Engineering Station must include the following interfaces:
•
•
For connecting the engineering station to the IOT2050 using SSH.
For connecting to a local IOT2050
For connecting to a local IOT2050
SD card slot
Ethernet port
Operating Instructions, 03/2024, A5E39456816-AF
SIMATIC IOT2050