Iot2050 Basic/Advance: Installing Mini Pcie Card - Siemens SIMATIC IOT Operating Instructions Manual

Expand device
5.3 Install Mini PCIe card
5.3.2

IOT2050 Basic/Advance: Installing Mini PCIe card

Applicable Configuration
This operation is only applicable for the following configurations:
• IOT2050 Basic: 6ES7647-0BA00-0YA2
• IOT2050 Advance: 6ES7647-0BA00-1YA2
Requirement
• The device is disconnected from the power supply.
• A Mini PCIe card
• Two M2 screws (supplied in accessory kit)
Procedure
The following example describes the installation of a Mini PCIe card, including mounting of
the antenna jacks. If the Mini PCIe card you install doesn't have an antenna, the work steps 4,
7 and 8 are not required.
Then follow these steps:
1. Remove the power plug and marked screws.
2. Loosen the top housing. Carefully press with the blade of a flat-blade screwdriver in the
marked recesses and carefully pull on the appropriate place on the top housing of the
enclosure.
3. Remove the top housing of the enclosure.
58
Operating Instructions, 03/2024, A5E39456816-AF
SIMATIC IOT2050