Supermicro X13DEG-M User Manual page 41

Preparing to Install the PHM into the CPU Socket
After assembling the Processor Heatsink Module, you are ready to install it into the CPU
socket. To ensure the proper installation, please follow the procedures below:
1. Locate four threaded fasteners (a, b, c, d) on the CPU socket.
d
(a, b, c, d: Threaded Fasteners)
2. Locate four PEEK nuts (A, B, C, D) and four rotating wires (1, 2, 3, 4) on the heatsink
as shown in the graphics below.
A, B, C, D: Peek Nut
1, 2, 3, 4: Rota�ng Wire
a, b, c, d: Threaded Fastener
Rota�ng Wire
Rota�ng Wire
Peek Nut
(Unlatched)
c
CPU Socket
a
Rota�ng Wire
B
4
D
b
d
(latched)
CPU Socket
1U Heatsink
41
Chapter 2: Installation
b
CPU Socket Pin1
2
Rota�ng Wire
C
A
Rota�ng Wire
Peek Nut
c
a
3
1