Table of Contents
Advertisement
Super X13DEG-M User's Manual
Console Redirection EMS
Select Enabled to use the SOL port for Console Redirection. The options are Disabled and
Enabled.
Console Redirection Settings (Available when "Console Redirection
EMS" above is set to Enabled)
Out-of-Band Mgmt Port
The feature selects a serial port in a client server to be used by the Microsoft Windows
Emergency Management Services (EMS) to communicate with a remote host server. The
options are COM1 and SOL/COM2. Please note that the option of SOL/COM2 indicates a
shared serial port. SOL is available with BMC support.
Terminal Type EMS
Use this feature to select the target terminal emulation type for Console Redirection.
Select VT100 to use the ASCII character set. Select VT100+ to add color and function
key support. Select ANSI to use the extended ASCII character set. Select VT-UTF8 to use
UTF8 encoding to map Unicode characters into one or more bytes. The options are VT100,
VT100+, VT-UTF8, and ANSI.
Bits Per Second EMS
This feature sets the transmission speed for a serial port used in Console Redirection.
Make sure that the same speed is used in the host computer and the client computer. A
lower transmission speed may be required for long and busy lines. The options are 9600,
19200, 57600, 115200, 230400, 460800, and 921600 (bits per second).
Flow Control EMS
Use this feature to set the flow control for Console Redirection to prevent data loss caused
by buffer overflow. Send a "Stop" signal to stop sending data when the receiving buffer
is full. Send a "Start" signal to start sending data when the receiving buffer is empty. The
options are None, Hardware RTS/CTS, and Software Xon/Xoff.
The following information is displayed:
Data Bits EMS / Parity EMS / Stop Bits EMS
Network Configuration
Network Stack
Select Enabled to enable Preboot Execution Environment (PXE) or Unified Extensible
Firmware Interface (UEFI) for network stack support. The options are Disabled and Enabled.
128
Advertisement
Table of Contents
