Supermicro X13DEG-M User Manual page 124

Super X13DEG-M User's Manual
Device Settings (Available when "Serial Port 2/SOL" is set to Enabled)
This feature displays the base I/O port address and the Interrupt Request address of serial
port 2 (or SOL).
Change Settings (Available when "Serial Port 2/SOL" is set to Enabled)
This feature specifies the base I/O port address and the Interrupt Request address of serial
port 2 (or SOL). Select Auto for the BIOS to automatically assign the base I/O and IRQ
address to serial port 2. The options are Auto, (IO=3F8h; IRQ=3;), (IO=2F8h; IRQ=3;),
(IO=3E8h; IRQ=3;), and (IO=2E8h; IRQ=3;).
Serial Port 2 Attribute (Available for Serial Port 2 only)
Select SOL to use serial port 2 as a Serial Over LAN (SOL) port for console redirection.
The options are SOL and COM.
Serial Port Console Redirection

COM1 (Available when your system supports the serial port of COM1)
Console Redirection
Select Enabled to enable COM port 1 for Console Redirection, which allows a client machine
to be connected to a host machine at a remote site for networking. The options are Disabled
and Enabled.
Note: This feature will be set to Enabled if there is no BMC support.
Console Redirection Settings (Available when "Console
Redirection" above is set to Enabled)
Terminal Type
Use this feature to select the target terminal emulation type for Console Redirection.
Select VT100 to use the ASCII Character set. Select VT100+ to add color and function
key support. Select ANSI to use the Extended ASCII Character Set. Select VT-UTF8 to
use UTF8 encoding to map Unicode characters into one or more bytes. The options are
VT100, VT100+, VT-UTF8, and ANSI.
Bits Per Second
Use this feature to set the transmission speed for a serial port used in Console Redirection.
Make sure that the same speed is used in the host computer and the client computer. A
lower transmission speed may be required for long and busy lines. The options are 9600,
19200, 38400, 57600, and 115200 (bits per second).
124