Supermicro X13DDW-A User Manual page 143

TPM Security Policy
When this feature is set to Enabled, passwords will be installed to protect the system and
storage devices as specified, and these passwords will be required to unlock the system or
devices. When this feature is set to Disabled, there will be no passwords used to protect the
system and storage devices. The options are Disabled and Enabled.
Load Authentication-Key
Select Enabled to allow the BIOS to load the Authentication-Key (File name: TPMAuth.bin)
from USB storage devices at next system boot. The options are Disabled and Enabled.
USB Security Policy
When this feature is set to Enabled, passwords will be installed to protect the system and
storage devices as specified, and these passwords will be required to unlock the system or
devices. When this feature is set to Disabled, there will be no passwords used to protect the
system and storage devices. The options are Disabled and Enabled.
Intel(R) Ethernet Controller (Ethernet controller) - (MAC address)
Note 1: This feature is available when "Onboard LAN Option ROM Type" is set to EFI.
Note 2: The Ethernet controller and MAC addresses shown above are based on you
system features.
Note 3: This submenu depends on the support of the Intel Optane PMem 300 series.
Firmware Image Properties
The following information is displayed:
•
Option ROM Version
•
Unique NVM/EEPROM ID
•
NVM Version
NIC Configuration
Link Speed
Use this feature to set the connection speed of a LAN port specified. The options are Auto
Negotiated, 10 Mbps Half, 10 Mbps Full, 100 Mbps Half, and 100 Mbps Full.
Wake On LAN
If this feature is set to Enabled, the LAN port specified will be enabled when the system is
powered on. The options are Disabled and Enabled.
143
Chapter 4: UEFI BIOS