Supermicro X13DDW-A User Manual page 137

LAN before it is assigned for physical interface; only a unique IP address will be used for
real-time interface. The default setting is 1.
Policy
Use this feature to select how the policy is to be configured. The options are automatic
and manual.
Advanced Configuration (Available when "Policy" is set to manual)
New IPv6 address
Use this feature to enter the IPv6 address for the local machine.
New Gateway addresses
Use this feature to set the gateway address for the local machine.
New DNS address
Use this feature to set the DNS server address for the local machine.
Commit Changes and Exit
Press <Enter> to save changes and exit. The options are Yes and No.
Discard Changes and Exit
Press <Enter> to discard changes and exit. The options are Yes and No.
Save Changes and Exit
Press <Enter> to save changes and exit. The options are Yes and No.
MAC:(MAC address)-IPv4 Network Configuration
Note: The display for this section will differ, depending on your system configuration.
Configured
Select Enabled to show whether the network address has been successfully configured.
The options are Disabled and Enabled.
Enable DHCP (Available when "Configured" is set to Enabled)
Select Enabled to support Dynamic Host Configuration Protocol (DHCP) which will allow the
BIOS to search for a DHCP server attached to the network and request the next available
IP address for this computer. The options are Disabled and Enabled.
137
Chapter 4: UEFI BIOS