Table of Contents
Advertisement
Hot Plug
Select Enabled to support Hot-plugging for the device installed on a selected SATA port to
allow you to replace the device installed in the slot without shutting down the system. The
options are Disabled and Enabled.
Spin Up Device
Select Enabled for Staggered Spin Up support to allow the SATA devices specified by the
user to spin up one at a time at boot up in an effort to prevent all hard drive disks from
spinning up at the same time, causing a power surge. The options are Disabled and
Enabled.
SATA Device Type
Use this feature to specify if the device installed on the SATA port specified by the user
should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
Trusted Computing (Available when a TPM device is installed
and detected by the BIOS)
When a Trusted-Platform Module (TPM) device is detected by your system, the following
information is displayed:
•
TPM 2.0 Device Found
•
Firmware Version:
•
Vendor:
Security Device Support
Select Enable to enable BIOS support for onboard security devices, which are not displayed
in the OS. If this feature is set to Enable, TCG EFI protocol and INT1A interface will not be
available. The options are Disable and Enable.
*When "Security Device Support" is set to Enable, the following information is displayed:
•
Active PCR banks
•
Available PCR banks
SHA-1 PCR Bank (Available when "Security Device Support" is set to Enable)
Select Enabled to enable SHA-1 PCR Bank support to enhance system integrity and data
security. The options are Enabled and Disabled.
127
Chapter 4: UEFI BIOS
Advertisement
Table of Contents
