Supermicro X13DET-B User Manual page 66

Super X13DET-B User's Manual
NC-SI Connector
The NC-SI (Network Controller Sideband Interface) connector is located at (JNCSI1). This
connector is used to connect a Network Interface Card (NIC) to the motherboard to allow the
onboard BMC (Baseboard Controller) to communicate with a network.
Note: For detailed instructions on how to configure Network Interface Card (NIC) set-
tings, please refer to the Network Interface Card Configuration User's Guide posted on
the web page under the link:
P1 NS1/P2 NS2/P2 NS3 Connectors
Three PCIe 5.0 x8 connectors are located at P1 NS1, P2 NS2, and P2 NS3 headers. P1 NS1
PCIe 5.0 x8 connector (NS1) is supported by CPU1, while P2 NS2 5.0 x8 (NS2) and P2 NS3
5.0 x8 (NS3) are supported by CPU2. Refer to the layout drawing below for the locations of
P1 NS1, P2 NS2, and P2 NS3 slots.
JUIDB1
UID_LED1
1
LE6
JVGA1
VGA
JPME1
UID
USB0/1
IPMI_LAN
(3.0)
SLOT1
BMC
BIOS
SATA 8~11
JTPM1
1
LE1
BT1
SATA1
JPME2
BIOS
LICENSE
BAR CODE
IPMI CODE
SATA 0~7
X13DET-B
REV:1.01
CPU1
SXB4
2
3
SXB3
SXB1
JPWR4
JPWR3
JPWR2
JPWR1
CPU2
https://www.supermicro.com/support/manuals/.
P1 AIOM PCIe 5.0 X16
JAIOM
PCH
JBT1
4
SXB5
66
1. NC-SI Connector (JNCSI1)
2. P1 NS1 PCIe 5.0 x8 (NS1)
3. P2 NS2 PCIe 5.0 x8 (NS2)
4. P2 NS3 PCIe 5.0 x8 (NS3)