Supermicro X13DET-B User Manual page 44

Super X13DET-B User's Manual
4. With a T30 bit torque driver set to a force of 8.0 in-lbf (0.904 N-m), tighten all PEEK
nuts in the sequence of A, B, C, and D with even pressure. To avoid damaging the
processor or socket, do not use excessive force when tightening the PEEK nuts. (For
best durability, 8.0 in-lbf torque is recommended.)
Important: Do not use a force greater than 8.0 in-lbf (0.904 N-m). Exceeding this force
may over-torque the screw, causing damage to the processor, heatsink, and nuts.
5. Examine all corners of the heatsink to ensure that the PHM is firmly attached to the
CPU socket.
1U Heatsink
2U Heatsink
44