Supermicro X13DET-B User Manual page 12

Super X13DET-B User's Manual
Quick Reference Table
Jumper Description
JBT1 CMOS Clear
JPME1 ME Recovery
JPME2 ME (Manufacture Mode) Select
LED Description
LE1 CPLD Heartbeat LED
LE6 Power Status LED
UID_LED1/ Rear Unit Identifier (UID)
LEDBMC LED/BMC Heartbeat LED
Connector
Battery (BT1)
BMC_LAN (IPMI_LAN1)
COM1 (JCOM1)
JAIOM
JNCSI1
JTPM1
JPWR1~JPWR4
NS1
NS2
NS3
Slot1
Slot2 + Slot2A
SXB1
SXB3
SXB4
SXB5 (NVMe M.2)
Note 1: For details on how to configure Network Interface Card (NIC) settings, please
refer to the Network Interface Card Configuration User's Guide posted on our website
under the link:
Note 2: For TPM support, an optional part is needed. Contact Supermicro Technical
Support for more information
Note 3: The SXB5 slot supports the SCC-P2HM2G4-B1 and the SCC-A2NM2241G3-
B1. The SCC-P2HM2G4-B1 supports two NVMe M.2 devices (up to Gen 4) in the
22110 form factor, and the SCC-A2NM2241G3-B1 supports two NVMe M.2 devices
(up to Gen 3) in the 2280 form factor.
Jumper Setting (Bold: Default)
Open (Normal)
Pins 1/2: Normal, Pins 2/3: ME Recovery
Pins 1/2: ME Mode
Status
On: Complex Programmable Logical Device (CPLD) Normal (Active)
Green: Power On
Amber: Standby Power
Red: Power Failure
Solid Blue (working as a UID LED): Unit Identified
Blinking Green (working as a BMC LED): BMC Normal (Active)
Solid Green: During BMC Reset or during a Cold Reboot
Description
Onboard battery
Dedicated BMC LAN port on the I/O backplane
Serial/COM port header
Supermicro Advanced input/output Module (AIOM) PCIe 5.0 x16 slot supported
by CPU1
NC-SI (Network Controller Sideband Interface) connector (See Note 1 below.)
Trusted Platform Module/Port 80 connector (See Note 2 below.)
6-pin power connectors (1~4)
P1 NS1 PCIe 5.0 x8 connector supported by CPU1
P2 NS2 PCIe 5.0 x8 connector supported by CPU2
P2 NS3 PCIe 5.0 x8 connector supported by CPU2
P1 Slot1 PCIe 5.0 x16 supported by CPU1
P2 Slot2/Slot2A PCIe 5.0 x16 to support riser card(s)
P2 SXB1 PCIe 5.0 x16 supported by CPU2
P1 SXB3 PCIe 5.0 x8 supported by CPU1
P1 SXB4 PCIe 5.0 x8 supported by CPU1
P1 SXB5 PCIe 5.0 x8 for two NVMe M.2 devices in the M-Key 2280 or 22110
format (depending on the type of riser card used) supported by CPU1 (See Note
3 below.)
https://www.supermicro.com/support/manuals/.
12