Table of Contents
Advertisement
Chapter 4: UEFI BIOS
Onboard LAN Device
Select Enabled to use the onboard LAN device. The options are Disabled and Enabled.
Onboard LAN1 Option ROM (Available when "Onboard LAN Device" is set to
Enabled)
Use this feature to select the type of device installed in LAN Port 1 used for system boot.
The options are Disabled, PXE, iSCSI, Legacy, FCoE, and EFI. Please note that available
options are based on your LAN OPROM ROM.
Onboard LAN2 Option ROM (Available when "Onboard LAN Device" is set to
Enabled and "Onboard LAN1 Option ROM" is set to Disabled or PXE)
Use this feature to select the type of device installed in LAN Port 2 used for system boot.
The default setting for LAN2 Option ROM is Disabled. Please note that available options are
based on your LAN OPROM ROM.
HTTP Boot Configuration
HTTP Boot Policy
Use this feature to set the HTTP boot policy. The options are Apply to all LANs, Apply to
each LAN, and Boot Priority #1 instantly.
HTTPS Boot Checks Hostname
Enable this feature for HTTPS boot to check the hostname of the TLS certificates to see if it
matches the host name provided by the remote server. The options are Enabled and Disabled
(WARNING: Security Risk!!).
Priority of HTTP Boot
Instance of Priority 1 (Available when your motherboard supports this feature)
This feature sets the rank target port. The default setting is 1.
Select IPv4 or IPv6
This feature specifies which connection the target LAN port should boot from. The options
are IPv4 and IPv6.
Boot Description
Use this feature to enter a boot description, which cannot be longer than 75 characters. Please
be sure to enter a boot description; otherwise, the boot option for the URI cannot be created.
Boot URI
Enter a Boot Uniform Research Identifier (URI) with 128 characters or shorter. This Boot URI
determines how IPv4 Boot Option and IPv6 Boot Option will be created. This feature is only
supported on Dual or EFI Boot Mode.
129
Advertisement
Table of Contents
