Cleaning And Maintenance - Fieldmann FZP 2030 E Manual

Log lying on the ground
Cut the log in half, then turn it over and finish it from the
opposite side.
Log above the ground
In part "A" make a cut from below to a third of the log and
then complete the cut from above. In part "B" make a cut
from above to a third of the log and then complete the cut
from below.
Removing a fallen tree
First, find out which way the branch is bent. Then make the
initial cut from the side of the bend and then complete the
cut from the opposite side.
ATTENTION!
A bent branch can be thrown out.

12. CLEANING AND MAINTENANCE

Cleaning the body of the chain saw
Keep the body of the chain saw clean. When cleaning, use a soft cloth dipped in a soap solution. Use this cloth to
meticulously clean the body of the chain saw.
Maintaining the guide bar
Most problems with the guide bar are due to uneven
wear.
Uneven wear usually occurs
due to incorrect chain sharpening
and incorrect adjustment of the depth gauge.
Uneven wear of the guide bar causes
the guide groove to widen (see Figure ). The result is
a rattling chain and rivets falling off. The chain saw
cannot be used for straight cuts. In such a case,
replace the guide bar for a new one.
Always check the condition of the guide bar before
sharpening the chain. Using a worn out or damaged
guide bar is very dangerous. Using a worn out or
damaged guide bar will result in damage to the
chain. Cutting
with such a tool will also be significantly more difficult
and more strenuous.
ELECTRIC CHAIN SAW
Cutting | Cleaning and maintenance
Guide bar
groove
Guide bar
Standard Guide bar with uneven wear
guide bar
15 EN
USER'S MANUAL