Storage - Fieldmann FZP 2030 E Manual

EN 18 Replacing the saw chain | Storage
Loosen and remove the guide bar bolt.
Remove the sprocket cover.
Remove the saw chain.
Wind the new chain around the cogged wheel, then along the top
groove of the guide bar and around the guide bar nose.
Note: Check that the saw teeth are facing in the correct
direction. Position the chain so that the teeth on the top of the bar
point towards the front edge of the bar (see figure).
Before placing the sprocket cover in position, make sure that the
chain tensioning adjusting point is inserted into the adjusting hole
of the guide bar.
Place the sprocket cover back on the saw body.
Secure the sprocket cover with the guide bar bolt.
ATTENTION!
Only tighten the bolt by hand.
Adjust the tension of the saw chain.
Tighten the guide bar bolt.
ATTENTION!
Check that you have not placed the saw chain on the guide bar in the opposite direction.
Otherwise, the chain saw will exhibit excessive vibrations and will not cut.

15. STORAGE

If you will not use the chain saw for longer than 30 days, proceed as follows.
Drain the oil tank.
Remove and clean the guide bar and chain. Submerge the guide bar and chain into a kerosene-based or
soap cleaning solution.
Then dry the guide bar and chain.
Place the chain in the oil container. This will prevent it from corroding.
Lightly coat the bar rail with oil.
Wipe the chain saw body with a cloth. When cleaning, use a soft cloth dipped in a soap solution.
Store the chain saw
• in higher shelves or in locked areas out of children's reach
• in a dry location
FZP 2030 E