Cleaning And Maintenance - Fieldmann FZP 2005-E Manual

Log lying on the ground
Cut it halfway through, then roll it over and complete the cut
from the other side.
Log above the ground
In part "A" make a cut from below to a third of the log and
then complete the cut from above. In part "B" make a cut
from above to a third of the log and then complete the cut
from below.
Removing a fallen tree
First fi nd out to which side the branch is bent. Then make the
initial cut from the side of the bend and then complete the
cut from the opposite side.
ATTENTION!
A bent branch may spring up.

12. CLEANING AND MAINTENANCE

Cleaning the body of the chain saw
Keep the body of the chain saw clean. When cleaning, use a soft cloth dipped in a soap solution. Use this cloth to
meticulously clean the body of the chain saw.
Maintaining the guide bar
Most problems with the guide bar arise due to uneven wear.
Uneven wear occurs mainly as a result of an incorrectly
sharpened chain or an incorrectly set depth gauge. When
the guide bar is worn out unevenly, the guiding groove is
widened (see Picture). The result is a rattling chain and
rivets falling off.
The chain saw cannot be used for straight cuts. In such
a case, replace the guide bar for a new one.
Always check the condition of the guide bar before
sharpening the chain. Using a worn out or damaged guide
bar is very dangerous. Using a worn out or damaged guide
bar will result in damage to the chain. Cutting with such
a power tool will also be much more diffi cult and
demanding.
ELECTRIC CHAIN SAW
Cutting | Cleaning and maintenance
Guide bar
groove
Guide bar
Standard
guide bar
15 EN
Guide bar with
uneven wear
USER'S MANUAL