Fieldmann FZP 2030 E Manual page 14

EN 14 Cutting
It is not necessary to push the chain saw into the cut. When the engine is running at full speed, push the
chain saw down lightly.
If the chain gets caught in the cut, do not try to release it by pulling, but open the cut with a wedge or lever.
Safety brake (protection against kickback)
This chain saw is equipped with a chain brake which, if working properly, stops the chain immediately in the
event of kickback. It is necessary to check the working order of the chain brake before every use of the chain
saw. Run the chainsaw at full speed for 1 - 2 seconds and then tilt the front protective cover. The chain must
stop immediately even when the engine is running at high speed. If the chain stops slowly or does not stop at
all, please contact an authorised service centre.
It is extremely important to check the functionality of the chain brake and the condition of the chain
sharpening before each use in order to maintain the necessary level of chain saw safety during kickback.
Removing safety accessories, incorrect maintenance or when using unsuitable guide bars or chains may, in
the event of kickback, result in serious injuries.
Felling trees
Decide on the direction of the tree fall, taking into account the wind
direction, the tilt of the tree and the position of the branch, and
consider all other factors before starting work.
The area around the tree must be unobstructed, free of obstacles
and must allow a stable position. The escape route must be
passable.
Make a wedge notch in one third of the diameter of the trunk on the
side where the tree is to fall. (see fig. Cutting trees, point 1)
On the opposite side, make a separating cut at a level above the
wedge notch. (see fig. Cutting trees, point 2)
The fall of the tree will be towards the wedge notch.
(see fig. Cutting trees, point 3)
ATTENTION!
When felling trees, inform other people in the area about the potential danger. Felling trees requires
experience and we do not recommend performing this task without the necessary experience.
Cutting logs
ATTENTION!
Always maintain a stable stance. Do not step on logs.
ATTENTION!
Before starting work, check that all components are in their place and that all nuts and bolts are tightened.
The cut log may roll away. Especially when cutting on a slope, always stand above the log being cut.
To prevent kickback, follow the instructions in the "Safety instructions" section.
Before starting work, assess the direction of the force causing the cut log to bend. The final cut needs to
always be done from the opposite side of where the bending force is acting to prevent the guide bar from
being clamped inside the cut.
Only operate the chain saw when the engine is switched off and the bar is protected by the protective cover.
Cutting trees
FZP 2030 E