Replacing The Saw Chain - Fieldmann FZP 2030 E Manual

File the tooth from the inside out (in direction B, see picture) until it is sharp. File only in this direction.
Note: Two to three passes of the file should be sufficient to sharpen the tooth.
Filing the depth gauge
As a result of sharpening the teeth on the chain, the depth gauge
tolerance is reduced. After every second or third sharpening, it is
necessary to adjust the depth gauge setting.
Place the tool for adjusting the depth gauge (see fig,
point 1) firmly on the upper edge of the two teeth. Make sure
that the groove of the tool fits into the groove of the depth
gauge
(see fig., point 2)
Use a medium-sized flat file (see fig., point 3).
File the depth gauge (see fig., point 4) to the level of the depth
gauge adjustment jig.
Remove the tool to adjust the depth gauge. Using a flat file,
round the front edge of the depth gauge (see figure). When
grinding, observe the prescribed values
(see fig., point 5).
Note: After several manual sharpenings, hand
the saw chain over to an authorised service centre for
sharpening or sharpen it with a special sharpening
machine.
This will renew the even sharpness of all teeth.

14. REPLACING THE SAW CHAIN

ATTENTION!
When replacing the saw chain, do not clamp the chain saw or the guide bar in a vice.
Always replace the chain if the teeth are excessively worn out and they cannot be sharpened or if the chain
snaps. Use only an original spare chain according to the specifications in this user's manual. When replacing
the saw chain, always also replace the cogged wheel of the sprocket. This will ensure the correct position of the
chain during movement. (Note: You will find the specifications of the correct chain type and the cogged wheel in
the technical specifications.)
ELECTRIC CHAIN SAW
Sharpening the saw chain | Replacing the saw chain
3
1
17
4
2
5
0,6 mm
USER'S MANUAL
EN