Usb & Sd Card Use; Setup Of Different Batteries - iCharger 4512DUO User Manual

USB & SD Card Use
4512DUO is the HID device of USB, supported by windows system directly, dispense with installing additional drivers. The
USB icon will light up on the lower right corner of the screen when the 4512DUO connects with computer normally.
The SD icon will light up on the lower right corner of the screen when the SD card is inserted. If 4512DUO connects with
the USB without running a program, the new added U disk can be found on the "My Computer" of the PC, and can operate
the file. Log files are stored in the
X:\Junsi\4512DUO\System
1. The file system of SD card must be FAT, FAT32 or exFAT.
2. Data in SD card needs to be backed up in case it is lost.
Setup of Different Batteries
The following form shows specific range of different batteries:
Nominal
voltage
LiPo
Lilo
LiFe
LiHV
LTO
NiZn
User
Pb
NiCd/NiMh
X: \ Junsi \ 4512DUO \Log
folder.
Charge
voltage
3.85V--4.35V
3.7V
Default: 4.20V
3.75V—4.35V
3.6V
Default: 4.10V
3.30V—3.80V
3.3V
Default: 3.60V
3.90V—4.45V
3.8V
Default: 4.35V
2.50V—3.10V
2.4V
Default: 2.85V
1.20V—2.00V
1.6V
Default: 1.90V
1.00V—4.60V
------
Default: 1.00V
2.00V—2.60V
2.0V
Default: 2.40V
1.2V ------
Dual Balance Charger/Discharger/DC Power
folder and config. files are stored in the
Discharge Storage
voltage voltage
3.00V—4.10V 3.70V—3.90V
Default: 3.50V Default: 3.85V
2.50V—4.00V 3.60V—3.80V
Default: 3.50V Default: 3.75V
2.00V—3.50V 3.10V—3.40V
Default: 2.50V Default: 3.30V
3.00V—4.25V 3.75V—4.10V
Default: 3.60V Default: 3.90V
1.50V—2.90V 2.40V—2.60V
Default: 1.80V Default: 2.50V
0.90V—1.60V
------
Default: 1.10V
0.50V—4.50V 1.00V—4.50V
Default: 1.00V Default: 1.00V
1.50V—2.40V
------
Default: 1.80V
------ ------
- 15 -
4512DUO
Support Support
Cells Balance
1-12s Yes
1-12s Yes
1-12s Yes
1-12s Yes
1-12s Yes
1-12s Yes
1-12s Yes
1-20s No
1-32s No