Buttons Function & Icons Description - iCharger 4512DUO User Manual

Buttons Function & Icons Description
Please refer to below chart for button functions
Operation
Symbols
Click the rotary switch
<>
Press the rotary switch
<>
for 2 seconds
Turn the rotary switch
<>
<TAB/SYS> Click TAB/SYS
<TAB/SYS> Press TAB/SYS for 2 seconds
< STATUS-x> Click STATUS-x
< STATUS-x> Press STATUS-x for 2 seconds
< STOP/START-x>
Press STOP/START-x for 2
< STOP/START-x>
seconds
Press
< STATUS-x> +
STOP/START-x at the same
< STOP/START-x>
time for 2 seconds
Press
< STOP/START-12> STOP/START-2 at the same
time for 2 seconds
Please refer to below chart for the icons on the interface:
Icon Function and Usage
Fan status: a. Grey shows not running
b. Green shows running (the higher the green shows, the faster the fan runs, and vice versa)
SD card status: a. Grey shows the SD card is not inserted
USB status: a. Grey for no USB connection
TYPE-C PD charge permit function
Click STOP/START-x
STATUS-x
STOP/START-1
b. Green shows the SD card has been inserted and can be used normally
b. Green for USB connection
c. Data transfer to PC, red dot flashes
Dual Balance Charger/Discharger/DC Power
Function
Initial interface: Enter CHANNEL SELECTION
Other interface: Confirm function or enter submenu
MEMORY SELECTION interface: Enter Management Menu
Other interface: Save and return to Previous Menu
Turn anticlockwise: The menu scrolls up or the adjustment
value becomes smaller
Turn clockwise: The menu scrolls down or the adjustment
value becomes larger
When the round button is pressed and turned the rotary switch
one time at the same time, it will be triggered automatically and
continuously before releasing the pressed button.
Startup interface: Enter SELECT INPUT POWER SUPPLY
Other interface: a. can act as backspace when editing program
name on MEMORY SETUP. b. Control out of focus c. Not
save and return to Previous Menu
Initial interface: Enter SYSTEM MENU
Other interface: Not save and return to Previous Menu
Program runtime: Switch the display information page of
CH-x channel
Initial interface: Start internal resistance measurement
Program runtime: The parameter change interface pops up
Initial interface: Enter MEMORY SELECTION; click again to
return the initial interface
Program runtime: Stop running program
Initial interface: Enter Run Program
Run Program Interface: Run the selected program
and
Initial Interface: Enter MONITOR SETTINGS
and
Run Program interface: CH-1 and CH-2 run the same program
- 8 -
4512DUO