Usb & Sd Card Use; Setup Of Different Batteries - iCharger DX8 User Manual

At the initial interface, long press < STATUS-x> and start measure internal resistance manually.
USB & SD Card Use
DX8 is the HID device of USB, supported by windows system directly, dispense with installing additional drivers. The USB
icon will light up on the lower right corner of the screen when the DX8 connects with computer normally.
The SD icon will light up on the lower right corner of the screen when the SD card is inserted. If DX8 connects with the
USB without running a program, the new added U disk can be found on the "My Computer" of the PC, and can operate the
file. Log files are stored in the
1. The file system of SD card must be FAT, FAT32 or exFAT.
2. Data in SD card needs to be backed up in case it is lost.
Setup of Different Batteries
The following form shows specific range of different batteries:
Nominal
LiPo
Lilo
LiFe
LiHV
LTO
NiZn
User
Pb
NiCd/NiMh
X: \ Junsi \ DX8 \Log
Charge
voltage voltage
3.85V--4.35V
3.7V
Default: 4.20V
3.75V—4.35V
3.6V
Default: 4.10V
3.30V—3.80V
3.3V
Default: 3.60V
3.90V—4.40V
3.8V
Default: 4.35V
2.50V—3.10V
2.4V
Default: 2.85V
1.20V—2.00V
1.6V
Default: 1.90V
1.00V—4.80V
------
Default: 1.00V
2.00V—2.60V
2.0V
Default: 2.40V
1.2V ------
Dual Balance Charger/Discharger/DC Power
folder and config. files are stored in the
Discharge
voltage
3.00V—4.10V 3.70V—3.90V
Default: 3.50V Default: 3.85V
2.50V—4.00V 3.60V—3.80V
Default: 3.50V Default: 3.75V
2.00V—3.50V 3.10V—3.40V
Default: 2.50V Default: 3.30V
3.00V—4.25V 3.75V—4.10V
Default: 3.60V Default: 3.90V
1.50V—2.90V 2.40V—2.60V
Default: 1.80V Default: 2.50V
0.90V—1.60V
Default: 1.10V
0.50V—4.50V 1.00V—4.50V
Default: 1.00V Default: 1.00V
1.50V—2.40V
Default: 1.80V
------
- 14 -
X:\Junsi\DX8\System
Storage Support
voltage Cells
1-8s
1-8s
1-8s
1-8s
1-8s
------ 1-8s
1-8s
------ 1-15s
------ 1-25s
DX8
folder.
Support
Balance
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
No