Charge/Discharge Setup & Use; Power Supply Setup - iCharger 4512DUO User Manual

Charge/Discharge Setup & Use
4512DUO can charge/discharge LiVH, LiPo, Lilo, LiFe, LTO, NiZn, NiMH, NiCd, Pb batteries, this manual will explain
and introduce in detail the charger's features, setup and use.
Power Supply Setup
The charger boots automatically when the power is turned on and the initial interface will display LOGO, charger relevant
information, power source and message etc.
1
2
4
6
System will delay 5 seconds after booting, during this period, long press <TAB/SYS>button to change the input source type,
while pressing any other buttons to enter the initial interface.
There are different parameter setting of these four types of power supply, the user can set in SYSTEM MENU
Limit see details on "Input Limit Setup".
After selecting the input power supply, confirm and enter the initial interface.
1
3
When the selected input power supply does not support recovery discharge, the icon " " in the lower left corner is gray;
It is displayed in green when recovery discharge is supported.
Dual Balance Charger/Discharger/DC Power
1 Logo
.
3 Firmware version
.
3
5 Input power voltage
.
5
7 Hint message
.
7
1. CH-1Channel Information Display
2. CH-2Channel Information Display
2
3. Status Display
- 10 -
4512DUO
2 Model
.
4 Serial number
.
6 Input power source
.
→
Input