Table of Contents
Advertisement
NiMH/NiCd Battery Discharge Setup
Select Program→Discharge to enter DISCHARGE SETUP interface.
NiMH/NiCd Battery Discharge Safety Setup
Click "Safety" to enter DISCHARGE SAFETY SETUP interface.
See details about setting on
NiMH/NiCd Battery Cycle Setup
Select Program→Cycle to enter CYCLE SETUP interface.
See details about setting on LiPo/LiIo/LiFe/LiHV/LTO/NiZn/User Cycle Setup
Pb Battery Setup
After adding program, it will switch to Pb battery in Type option on the MEMORY SETUP interface. Set the number of cells
and capacity, after editing all parameters for program, click "Save" to save and return to the previous interface.
As shown in above picture, the program of Pb battery has the following modes: Charge, Discharge and Cycle.
Pb Battery Charge Setup
Select Program→Charge to enter PB CHARGE SETUP interface.
1. The charger first charges with constant current (CC) according to the user setting then turns to constant voltage (CV)
when the charging voltage reaches the peak point. In the CV phase the current gradually falls, and the charger will
terminate charging when the current falls below the percentage of the configured charge current.
2. Charge mode has Normal, Reflex two modes available, about the Reflex mode (Reflex) please see Important Notes.
Pb Battery Charge Advanced Setup
Click "Advanced" to enter PB ADVANCED SETUP interface,
LiPo/LiIo/LiFe/LiHV/LTO/NiZn/User Discharge Safety
Dual Balance Charger/Discharger/DC Power
Discharge Current:
0.05A-45A; default: 2A
Discharge Voltage:
0.1V- 50V; default: 0.8V
End Current:
1%-100%; default: 50%
Regenerative Mode:
Cells: 2 -20S; default: 6S
Capacity：Ignore(default),50-999900mAh
Chg Current:
0.05A-45A; default: 2A
Chg Mode:
Normal (default), Reflex
Chg End Current:
1%-50%; default: 10%
Chg Cell Volt:
2V/Cell-2.6V/Cell; Default: 2.4V/Cell
- 23 -
OFF (default), To input, To channel
Setup.
4512DUO
Advertisement
Table of Contents
