Run Program For Charger - iCharger 4512DUO User Manual

1. Channel Mode has asynchronous, synchronous available, see more details on Connection for Charger
2. If select synchronous mode, the maximum charge/discharge current setting will change from 45A to 80A.
3. If tick Auto saves before the program runs, the parameters set on the Run program will be saved automatically, and
the Run Program will display "Auto save" ( shown in the following left picture), otherwise it will display "Don't save!"
(shown in the following right picture); for the built-in program, the Auto save before the program runs option is ticked
by default.
Run Program for Charger
After selecting program on MEMORY SELECTION, click to enter Run Program interface (press <STOP/START-x> on
the initial interface will enter Run Program from the last running program), as below:
1
1. The revised common parameters of built-in program will be saved by default automatically after running, while the
program customized by the user can be set to be saved or not in MEMORY SETUP→MEMORY OPTION→Auto save
before the program runs.
2. After setting the Cap. value, when the Current value exceeds the certain value, the system will show a warning and
alarm. The Current value of each battery type is: LiXX battery > 3C, NiMH/NiCd battery > 2C, Pb battery > 0.3C, NiZn
battery>2C.
3. Turn <> to choose Run Program, the common parameters are in grey, which is inalterable; if needs to change, the
user can press <TAB/SYS> as below:
Dual Balance Charger/Discharger/DC Power
Channel Mode:
Auto save before the program runs:
modified parameters will be saved automatically;
default: ticking
Run Counter:
Log Interval:
Log save to SD card:
If ticking, the Log will be saved to SD card
1 Run Program Selection
.
2
2 Common Parameters Setup
.
3 Auto-save Hint
.
3
- 12 -
Asynchronous (default); Synchronous
0-999; default: 0
0.2-60Sec; default: 1Sec
4512DUO
if ticking, the