Table of Contents
Advertisement
Questions and Answers
Question
Why does the height and
shape of each loaf differ?
Kneading blade comes out
with the bread
Bread has floured corners
Can ingredients be halved or
doubled?
Can fresh milk be used
instead of powered milk?
Bread is deflated and not
made properly
Why is there grease found on
the bread?
Display shows 0:00 and is
flashing
The display shows 'HHH' or
'LLL'
The display shows 'EE0" and
continuously beeps
The display shows "EE1" and
continuously beeps
Can the bread maker settings
be changed after the bread
maker has started?
25
It is normal for the height and shape of each loaf to vary depending on
the ingredients, accurate measurement of ingredients and the room
temperature.
This can happen as the kneading blade is removable for easy cleaning.
Use the supplied hook to remove the blade from the loaf.
Caution: Kneading blade or the bonus blade hook will be hot. Allow bread
to cool before removing blade.
This may occur if the flour is not mixed in completely to the dough.
Check bread about 10 minutes into the kneading cycle. If all the flour
is not incorporated, use a silicon spatula to remove the flour from the
sides of the bread pan so it can be incorporated into the dough.
Bread may also have floured corners if the pan is not inserted properly.
Ensure it is clicked into place, before you start the machine.
No. if there is too little in the bread pan, the blade will not be able to
knead well. If there is too much, the bread may rise out of the bread
pan.
Yes. Be sure to decrease the same measurement of water to equal
liquid substitution. Fresh milk is not recommended when using the
Delay Timer, as it may spoil in the bread pan.
Bread can be heavily affected by season and dry heat. Please add more
water to bring the flour together.
It is important to wipe clean the bread pan and kneading blade before
use.
The baking cycle is complete and the bread maker is in keep warm
mode. Press Start/Stop to turn off the keep warm feature.
The internal temperature of the baking chamber is too high or too low.
Let the unit rest before using again.
Temperature sensor circuit is broken. Call customer service team.
Temperature sensor circuit is bypassed. Call customer service team.
No, the bread maker can only be reset by holding the Start/Stop button
for 3 seconds.
Answer
Advertisement
Table of Contents
