Pressure Test; Hydro Rupture Setup; Inspection Mode - Smartrise C4-H Installation And Testing Procedure

Table of Contents

..C4-H Testing

Procedures..

6. Verify a Lock Open fault displays.

7. Remove the jumper from MM and toggle the NORMAL/INSPECTION switch to Normal. The doors

close.

8. Recycle the MR board to clear the faults.

9. The car moves back to door zone.

8.4 Pressure Test

Applicable Codes – ASME A17.1/B44-19 sections 2.25.3 and 3.17.1.2

The pressure test ensures the motor's bypass valve and stop ring operate normally.

The following procedure describes how to test for pressure.

1. Verify the hoistway and the car top are clear of any personnel.

2. Enter a car call to the top landing by navigating to MAIN MENU | DEBUG |ENTER CAR CALLS.

3. Toggle the NORMAL/INSPECTION switch to INSPECTION.

4. Navigate to MAIN MENU | SETUP | MISCELLANEOUS | BYPASS TERM LIMITS and set to ON.

5. Press and hold Enable and Up buttons. Run the car slowly up onto stop ring.

6. Verify the car stops on the stop ring.

7. Navigate to MAIN MENU | SETUP | MISCELLANEOUS | BYPASS TERM LIMIT and set to OFF.

8. Toggle the NORMAL/INSPECTION switch to NORMAL.

This test can be performed in either Inspection Mode or Normal Mode.

Setup and adjust the rupture valve while the car is moving at the highest speed possible down a multi-run

floor. The controller may exhibit a low-pressure fault as a result of this test.

a. If the Contract Speed is < 150 FPM, increase the Inspection Speed to 150 FPM and run the car on

Inspection Mode. Go to Section 8.5.1.

b. If the Contract Speed is > 150 FPM, run the car on Normal Mode. Go to Section 8.5.2.

Applicable Code – ASME A17.1/B44-19 section 3.19.3.3.1.

The following procedure describes how to setup for hydro rupture on Inspection Mode.

1. Place a car call above the bottom landing by navigating to MAIN MENU | DEBUG |ENTER CAR

CALLS.

2. Toggle the NORMAL/INSPECTION switch to INSPECTION.

Inc.

Table of Contents