Using Ethernet - Digital Equipment DECsystem 5100 Installation Manual

To find the unit number of your tape drive:
Enter the following command at the console prompt
(>>)
and press Return.
>>
conf -b
The system displays its configuration, similar to the following:
hardware: revision 1
firmware: revision 1
ethernet hardware address: 08-00-2b-12-7f-58
option board: Asynch Comm, 8 ports
memory: total size 16MBs
scsi peripherals
unit type product
0 disk RZ56 (C) DEC
3 tape TZKSO
5 tape TZ30
7 host adapter
>>
removable/fixed
fixed
removable
removable
2 Examine the configuration display for either of the following lines, and
make a note of the unit number associated with it:
5 tape TZ30 removable
or
3 tape TZK50 removable
In
the configuration display shown previously, you can see that the TZ30
tape drive has the unit number 5, and the TK50Z tape drive expansion box
has the unit number 3.
To install your ULTRIX software, see Section 6.2.
6.1.2 Using Ethernet
When using Ethernet to install your ULTRIX software on a hard disk, you
need to have the following:
• A connection to Ethernet
• An internal hard disk drive (RZ24), or a disk drive expansion box (RZ55,
RZ56, or RZ57).
To install your ULTRIX software, see Section 6.2.
6-2 Installing Software