Connecting A Transceiver Cable To Your System; Connecting A Transceiver Cable - Digital Equipment DECsystem 5100 Installation Manual

5.4.2 Connecting a Transceiver Cable to Your System
A transceiver cable is the physical connection between a standard Ethernet
network interface and a DECsystem 5100. You use a transceiver cable when
you want to connect your system to an H4000 transceiver or DELNI which is
attached to the standard Ethernet cable. To connect a transceiver cable to your
system:
Set the system unit on/off switch to the off
(0)
position.
2 Attach the 15-pin connector on the standard Ethernet transceiver cable to
the back of the system unit.
3
Use a screwdriver to move the sliding lock (part of standard Ethernet
connector) and make the standard Ethernet connection secure.
Figure 5-4 shows the correct connection.
Figure 5-4
Connecting a Transceiver Cable
RE_EN05166A_90
Connecting to a Network 5-7