Unpacking An Expansion Box; Expansion Box And Accessories - Digital Equipment DECsystem 5100 Installation Manual

4.4 Unpacking an Expansion Box
Each expansion box is shipped from the factory with the following accessories:
• One 50-pin to 50-pin cable. Use this cable to connect the expansion box to
the system unit or to other expansion boxes.
• One power cord.
• One 50-pin terminator. Use this to terminate the last expansion box.
• One cable with a 68-pin connector at one end and a 50-pin connector at the
other end. This cable is not used with DECsystem 5100.
• Some expansion boxes are shipped with test media. For example, the
TK50Z tape drive expansion box is shipped with a blank tape.
Note The figures in this chapter show one example of an expansion box. Your
expansion box might be different.
Figure 4-3 shows all the parts that you need to set up your expansion box.
Make sure that you have each part shown.
Figure 4-3
Expansion Box and Accessories
50-Pin to 50-Pin - - - - -
Connector Cable
Terminator----~-------~
Power C o r d - - - - - - - = - - - - - - - - - - - - - - - -
4-6
Installing Peripheral Devices
ML0-002749