Installing Connector Covers - Digital Equipment DECsystem 5100 Installation Manual

2.3 Installing Connector Covers
The three connector covers, provided with your system, protect the unused
connectors on the back of the system unit. After you have identified the ports
and connectors, you can install covers on the unused connectors as determined
by your system configuration.
Note If the DHTBO asynchronous module is installed, MMJ ports 4 to 10 are visible,
see Figure 2-1.
If the DHT80 asynchronous module is not installed, first install cover 2
(74-38973-01), then install cover 1 (74-38974-01). See Figure 2-3 A.
Note
Due to the construction of the covers, you must install cover 2 first.
If the DHT80 asynchronous module is installed, but you are not using the
second modem port (see Figure 2-1), you can cover it, using cover 1. See
Figure 2-3 B.
If you do not want to use the external SCSI interface, install cover 3 (74-38975-
01). See Figure 2-3 A and B.
2-4 Installing Your DECsystem 5100