Connecting To A Standard Ethernet Network; Setting The Network Select Button For Standard Ethernet; Connecting The T-Connector To The Back Of The System Unit - Digital Equipment DECsystem 5100 Installation Manual

Figure
5-3 Connecting the T-Connector to the Back of the System Unit
RE_EN05165A_90
5.4 Connecting to a Standard Ethernet Network
If you are connecting a work group to an existing network, ask the network
coordinator for the best way to connect your work group to the larger network.
Have the network coordinator make sure that all node names and node
addresses are unique and do not already exist in the larger network.
5.4. 1 Setting the Network Select Button for Standard Ethernet
To use standard Ethernet on your system, set the network select button on the
back of the system unit to the out position. When you turn on your system,
the green light beside the standard Ethernet connector comes on and the light
beside the Thin Wire Ethernet is off. You are ready to connect to standard
Ethernet.
5-6 Connecting to a Network