Maintenance; Safety Instruction; General Recommendations For Ventilation System Maintenance; Cover Opening - Salda RIRS EKO 3.0 400 VEL Mounting And Installation Instruction

6. MAINTENANCE

6.1.

SAFETY INSTRUCTION

Unplug the unit from the mains before opening the door (disconnect the power plug from the outlet or in case a two-pole
automatic circuit breaker is installed, disconnect it as well. Make sure that it cannot be turned on by the third parties) and wait
until the fans completely stop (for about 2 min.).
6.2.

GENERAL RECOMMENDATIONS FOR VENTILATION SYSTEM MAINTENANCE

COMPONENT
Filters
Fans
Rotor heat exchanger
Control panel
Electric heater
Temperature sensor
Air supply and extract system
Air duct system
6.3.

COVER OPENING

RIRS 400-700 V EKO 3.0 v2023.1
DURING START-UP
Check the connections and the direction of rotation
Check the cleanliness of the heat exchanger
Check the connections
Check the connections
Check electrical connections
Check the connections
Check the tightness
Check the tightness of connections
AT LEAST EVERY 6 MONTHS
control device indications.
Check cleanliness. Clean, if necessary
Make sure that the impellers are not unbalanced.
rotated by hand.
free of mechanical damage.
Check electrical connections and make sure that these
are secured properly and are free of signs of corrosion.
Check cleanliness and clean, if necessary
Check the tension of a belt
Check the connections
connections of the heater
Check the operation
Clean
Clean
Clean
Every 3 to 4 months, visually assess the functioning
casing has no signs of melting or is not thermally dam-
aged and does not produce any unusual sounds. All the
contactors in the product or in its accessories must be
checked.
EN | 13