Unit Placing And Mounting Positioning Requirements; Floor Mounting; Connection Of The Air Duct; Connection Of The Unit To The Electric Network - Salda RIRS EKO 3.0 400 VEL Mounting And Installation Instruction

5.5.1. UNIT PLACING AND MOUNTING POSITIONING REQUIREMENTS

Figure 5.5.1.1

5.5.2. FLOOR MOUNTING

• The installation should be performed having positioned the units in
• Install the supporting legs.
• The units are assembled from separate sections.
•
•
5.6.

CONNECTION OF THE AIR DUCT

•
•
•
pressure and noise level, you can increase the diameter.
• In order to reduce the level of noise in the air supply system, install silencers (see the chapter on air supply system installation).
•
• External air and exhaust system piping should be isolated in order to prevent heat loss and condensation.
•
from potential air pollution sources.
• When installing air ducts next to the ventilation equipment, brackets must be used. They suppress vibration and assure secure installation of the
• Air ducts are often mistakenly connected in an inappropriate location. The ventilation units bear the labels indicating the correct air duct connec-
5.7.

CONNECTION OF THE UNIT TO THE ELECTRIC NETWORK

•
•
•
• The unit must be earthed according to electrical equipment installation
•
•
•
•
made during transportation.
•
The manufacturer does not assume any liability for personal injuries and property damage due to non-conformance with the
provided instructions.
RIRS 400-700 V EKO 3.0 v2023.1
L
1,5xL
the horizontal direction only.
"DIMENSIONS AND WEIGHT".
the electro-technical
regulations.
after the evaluation of
H
operation, control, and measurement nodes)
-
-
EN | 11