Mounting - Salda RIRS EKO 3.0 400 VEL Mounting And Installation Instruction

THE LIST OF COMPONENTS
PV Supply air fan
PF
TE Exhaust air temperature sensor
DTJ Extract air temperature and humidity sensor
PC Computer
M2 Outdoor air damper actuator
TL Outdoor air temperature sensor
MB-Gateway
R Rotor heat exchanger
KV1 Water heater*
M4 Water heater circulation pump*
RC2 Stouch, Flex or ST-SA-Control remote control panel
TV1 Water heater temperature sensor*
* Component/possibility to connect it depends on model.
POSSIBLE PCB INPUTS/OUTPUTS
FA Fire alarm
5.5.

MOUNTING

• Installation
• When connecting air ducts, consider the labels on the casing of the unit.
• Before connecting to the air duct system, the connection openings of
•
• Do not connect the bends close to
•
•
• If the ventilation unit is
fans is admissible,
mounting
• Ducts are connected to the unit in such
out maintenance, service and/or
tion signs may occur.
10 | EN
the
, it may transmit noise vibrations to the premises. Though the level of noise generated by the
mounting the unit at a
a
Figure 5.5.1
IF
IV Exhaust fan
TJ Supply air temperature sensor
CO CO sensor
2 2
KE1 Electric heater*
M3 Exhaust air damper actuator
Ventilated premises
NET
DX DX cooler
T1 Water heater thermostat*
M5 Water cooler valve motor
M6 Water heater valve motor*
M1 Rotor motor
H1 Working indication output
H2 Alarm indication output
the ventilation unit should be closed.
, and the coil
W
RIRS 400-700 V EKO 3.0 v2023.1
-