Sony STR-DG600 Operating Instructions Manual page 83

Radio stations cannot be tuned in.
• Check that the antennas are connected
securely. Adjust the antennas and connect
an external antenna, if necessary.
• The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 62).
• Press DISPLAY repeatedly on the receiver
so that the frequency appears on the
display.
There is no picture or an unclear
picture appears on the TV screen or
monitor.
• Select the appropriate input using tile input
buttons.
• Set your TV to the appropriate input mode.
• Move your audio components away from
the TV.
• Assign the component video input
correctly.
The MULTI CHANNNEL DECODING
lamp does not light up in blue.
• Check that the playback component is
connected to a digital jack and the inpnt is
selected properly on this receiver.
• Check whether the input source of the
software being played back corresponds to
the multi channel format.
• Check whether the setup on the playback
component is set to multi channel sound.
Remote control
The remote does not function.
• Point the remote at the remote sensor on
the receiver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on
the remote.
• The 12 button on the remote is not
available for receiver operation.
Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
system by the message. Refer to the I_llowing
table to solve the problem. If any problem
persists, consult your nearest Sony dealer.
If an error message appears while you perform
Auto Calibration, see "Error and warning
codes" (page 34) to solve the problem.
DEC. EROR
Appears when a signal the receiver cmmot
decode (ex. DTS-CD) is input and "DEC.
PRI." on the AUDIO menu is set to "DEC.
PCM". Set it to "DEC. AUTO" (page 42).
PROTECT
Irregular current is output from the
speakers. The receiver will antomatically
turn off alter a few seconds. Check the
speaker connection and turn on the power
again.
i
3
continued,
83us