Sony STR-DG600 Operating Instructions Manual page 33

The table below shows the display when
nleasnrelnent starts.
Tips
• You can also fix the optimizer microphone to a
tripod (not supplied) and place tile tripod at your
listening position.
• Be sure to remove any obstacles in tile path
between tile optimizer microphone and the
spe,',kers.
• When you face the speaker towards the optimizer
microphone, you will get a more accurate
measurement.
Input
Control
button --
.... _iiiii!iiiiili!iiiiii!_iiiiiii!i_ii_i!!
flit!; ;_
MUTING
MASTER
VOL+/-
AUTO
-- CAL
Press AUTO CAL.
The following appears on the display.
A.CAL 15] --+ A.CAL 14] --+ A.CAL [3] --+
A.CAL 12] -+ A.CAL 111
Measurement for Display
Environment noise level NOISE.CHK
Speaker connection MEASURE and SP
DET. appears
alternately:
Speaker level MEASURE and
GAIN appears
alternately:
Speaker distance MEASURE and
DISTANCE appears
alternately:
' The corresponding speaker indicator lights up in
the display during measurement.
When measurement ends, "COMPLETE"
appears on the display and the settings are
registered.
Notes
• Auto Calibration canuot detect tile sub v_ool'cr.
Therefore. all sub woofer settings will be
maintained.
• You cannot select Auto Calibration when
headphone is c(mnected.
• The measurement process will take a few minutes
to complete.
Tips
• When Auto Calibration starts:
Stand some distance lhom the speakers and the
listening position to avoid measurement failure.
This is because test signals are output Dora the
speakers during measurement.
Avoid making noise to get a more accurate
measurement.
• The Auto Calibration function will be canceled
when you do the following during the
measurement process:
Press I/(_), input buttons or MUTING.
Change the volume level.
Press AUTO CAL again.
if)
-1
33us