Sony STR-DG600 Operating Instructions Manual page 34

Error codes
When an error is detected during Auto
Calibration, an error code will appear on the
display cyclically after each measurement
process as follows:
Error code -_ blank display -_ (error code -_
blank display) a) -_ PUSH -_ blank display
-_ ENTER
a)Appears when there are
more
thau
oue
error code.
To rectify the error
1 Record
down the error code.
2 Press the control button.
3 Press I/(.D to turn off the receiver.
4 Rectify the error.
For details, see "Error code and remedies"
below.
5 Turn on the receiver and perform Auto
Calibration again (page 33).
Error code and remedies
Error Explanation Remedies
code
ERROR 10 The enviroun/ent Make sure tile
is too noisy, environment is
quiet during Auto
Calibration.
ERROR Il The speakers are Placeyourspeakers
placed too near further a_W from
tile optimizer tile optimizer
microphone, microphone.
ERROR 20 Front speakers Check tile front
are not detected speaker
or only oue lhout counection.
speaker is
detected.
ERROR 21 Only one Check tile surround
surround speaker speaker
is detected, counectiou.
Error Explanation Remedies
code
ERROR 22 Only one
surround back
speaker is
detected.
ERROR 23 Surround back
speaker is
detected but
surround
speakers are not
connected.
Check the surround
back speaker
counection. If you
counect only one
surround back
speaker, conuect it
to the SPEAKERS
SURROUND
BACK L termiuah
Be sure to conuect
the surround
speakers.
Warning codes
During Auto Calibration, the warning code
provides information on the measurement
result. The warning code will appear on the
display cyclically as follows:
Warning code _ blank display _ (warning
code _ blank display) b) _ PUSH _ blank
display _ ENTER
b)Appears when there are more than one warning
code.
You can choose to ignore the warning code as
the Auto Calibration function will
automatically adjust the settings. You can also
change the settings manually.
To change the settings
manually
1 Record
down the warning code.
2 Press the control button.
3 Press I/(.D to turn off the receiver.
4 Follow the solution provided in the
%Varning code and solution" below.
5 Turn on the receiver and perform Auto
Calibration again (page 33).
34us