Mecmesin OmniTest 0.5 User Manual page 5

1 OmniTest Single Column Test Systems User Manual
2 Introduction
2.1 User Manual Icons
2.1.1 Warning
2.1.2 Caution
2.1.3 Information
3 System Diagrams
3.1 OmniTest 0.5, 1.0, 2.5 and 5 System Details
3.2 OmniTest 7.5 System Details
3.3 Rear Connectors Panel
3.3.1 OmniTest 5 and 7.5
3.3.2 OmniTest 0.5, 1 and 2.5
4 Unpacking and Parts Supplied
4.1 Inspection and Unpacking
4.2 Packaging
4.3 Moving the Test Stand
4.4 Parts Supplied
4.5 Accessories Available
5 Initial Setup
5.1 Mains Power Supply
5.1.1 Fuse Specification
5.2 Fitting Foot Clamps
5.3 Connecting the OmniTest Stand to a PC
5.3.1 Cable Management
5.4 Updating Stand Firmware: Vector Instrument Programmer (VIP)
5.4.1 Pre-requisites
5.4.2 How to use VIP
5.5 Attaching Grips and Fixtures
5.6 Setting the Limit Stops
6 Enhanced Load Sensor (ELS) Setup
6.1 Mounting an ELS to an OmniTest 0.5, 1.0, 2.5 and 5 (Dovetail bracket)
6.2 Mounting an ELS to an OmniTest 7.5
6.3 Connecting an ELS to the OmniTest Stand
7 Front Panel Controls
7.1 Emergency Stop
7.2 Multi-function Scroll Wheel Control
7.2.1 Scroll Wheel Colour Indication
7.2.2 Jog Mode
7.2.3 Navigational Control
7.2.4 The Central Button
7.3 OmniTest Display Panel
7.4 Test Stand States
7.5 On-Screen Icons
7.5.1 A: Pre-Test
7.5.2 B: Test Stop
7.5.3 C: Jog Mode
7.5.4 D: Settings Menu
8 OmniTest Single Column Settings
8.1 Jog settings
8.2 PIN Code
5