Teletype 28 Manual page 81

3.04 Horizontal Tabulator Mechanism (Cont.)
ISS 8, SECTION 573-115-700TC
HORIZONTAL TABULATOR SLIDE
REQUIREMENT
OPERATING LEVER IN
OPERATED POSITION.
SLIDE ARM IN UNOPERATED
POSITION.
MIN. 1-1/2 OZ.
MAX. 4-1.12 OZ.
TO START SLIDE ARM MOVING.
STRIPPER BAIL ARM
STRIPPER BAIL ARM SCREW •
OPERATING LEVER CAM ARM SPRING
HORIZONTAL TABULATOR SLIDE ARM SPRING
HORIZONTAL TABULATOR SLIDE ARM
LEVER
CAM PLATE
STRIPPER BAIL
~
OPERATING LEVER CAM ARM SPRING
REQUIREMENT
OPERATING LEVER IN UNOPERATED
POSITION. HORIZONTAL TABULATOR
FUNCTION PAWL UNLATCHED.
MIN. 4 OZS.
MAX. 9 OZS.
TO START STRIPPER BAIL MOVING.
CAM PLATE STRIPPER BAIL
REQUIREMENT
OPERATING LEVER AND TABULATOR
SLIDE ARM IN UNOPERATED POSITIONS.
SPACING CLUTCH ROTATED UNTIL
HIGH PART OF RESTORING CAM IS
OPPOSITE STRIPPER BAIL CLEARANCE
BETWEEN RESTORING CAM AND STRIPPER
BAIL.
MIN. 0.010 INCH
MAX. 0.025 INCH
TO ADJUST
POSITION STRIPPER BAIL PLATE ON
STRIPPER BAIL WITH STRIPPER BAIL ARM
SCREW FRICTION TIGHT. TIGHTEN
SCREW.
RESTORING CAM
(LEFT SIDE VIEW)
TRANSFER BAIL EXTENSION ARM
:A-DJUSTING SCREW
(BOTTOM VIEW)
SPACING CUT -OUT TRANSFER BAIL
SET COLLAR
REQUIREMENT
TRANSFER BAIL SHOULD HAVE
SOME END PLAY.
MAX. 0.008 INCH
TO ADJUST
POSITION SET COLLAR WITH
SCREW LOOSENED. TIGHTEN SCREW.
Page 81