Teletype 28 Manual page 129

4.05 Main Shaft and Trip Shaft Mechanisms
(A) CLUTCH TRIP SHAFT SET COLLARS
(1}
Requirement
Spacing clutch latchlever should
have side play
Min some---Max 0. 008 inch
To Adjust
Position spacing clutch Iatcblever set
collar. Tighten screw.
SPACING CLUTCH LATCH-
LEVER ·sET COLLAR
SPACING CLUTCH
TRIP SHAFT
ISS 8, SECTION 573 ·115-700TC
(2) Requirement
Approximate alignment of right end
of stop extensions on trip lever and
shoe lever.
To Adjust
Position line feed clutch trip lever set
collar. Tighten screw.
(3) Requirement
Line feed clutch latchlever should
have side play
. . - - - - - - Min some---Max 0.008 inch
To Adjust
Position line feed clutch latchlever set
collar. Tighten screw.
LINE FEED CLUTCH
LATCHLEVER SET
COLLAR
(Rear View)
Note: Antideflection plate adjustment applies
only to units so equipped.
(B) ANTIDEFLECTION PLATE
l
Requirement
wah typing unit upside down and function,
I
spacing, line feed, and typebox clutches
(11
b1
~
latched disengaged
~
L -_ _ _
Min 1 lb---Max 5 lb
(Left Side View, Upside Down)
to pull trip shaft away from antideflection
plate.
To Adjust
Position plate with mounting screws
loosened. Tighten screws.
Page 129