Teletype 28 Manual page 78

SECTION 573-115-700TC
3. VARIABLE FEATURES
3.01 Horizontal Tabulator Mechanism
TRIP LEVER ARM
(LEFT VIEW)
NOTE: FOR EARLIER DESIGN SEE PARS. 4.24 THROUGH 4.29.
SPACING CLUTCH STOP LEVER
REQUIREMENT
SPACING CLUTCH DISENGAGED.
TRIP LEVER ARM AND INTERMEDIATE
BAIL IN THEIR UPWARD POSITION.
THE OUTER SURFACE
0
F THE TRIP
LEVER SHOULD BE FLUSH WITH THE
OUTER SURFACE OF THE SHOE LEVER
OR UNDER FLUSH TO .010 INCH.
CHECK AT STOP LUG WITH LEAST
BITE.
TO ADJUST
v~
WITH ADJUSTING SCREW FRICTION TIGHT
POSITION SPACING CLUTCH STOP LEVER.
TIGHTEN SCREW.
NOTE
IF THIS ADJUSTMENT IS CHANGED, CHECK
THE LATCH BAIL ADJUSTING PLATE - PAR. 3.03
SPACING CLUTCH
TRIP LEVER SPRING
CLUTCH TRIP LEVER
Page 78
SHOE LEVER
SPACING CLUTCH
CLUTCH STOP LEVER SPRING
REQUIREMENT
SPACING CLUTCH ENGAGED. RO-
TATE CLUTCH UNTIL STOP LE.VER RESTS
ON STOP LUG.
MIN. 11-1/4 OZS.
MAX. 14-1/4
OZS.
TO MOVE STOP LEVER AWAY FROM
STOP LUG.
(LEFT VIEW)