Teletype 28 Manual page 45

2. 40 Spacing Mechanism (Cont.)
FUNCTION PAWL
CARRIAGE RETURN
FUNCTION BAR
UNSHIFT ON SPACE
(REAR VIEW)
(LEFT Sl DE V lEW)
-STRIPPER BLADE
RIGHT SIDE FRAME
CARRIAGE RETURN LEVER - - - - - - _ _ _ ,
REQUIREMENT (UNITS EQUIPPED WITH ONE-
STOP FUNCTION CLUTCH)
CARRIAGE RETURN FUNCTION SET UP
ON SELECTOR. MAIN SHAFT ROTATED
UNTIL FUNCTION CLUTCH STOP LUG IS
TOWARD BOTTOM OF UNIT. CARRIAGE
RETURN FUNCTION PAWL HOOKED OVER
ITS FUNCTION BAR. SPACING DRUM HELD
SO THAT CARRIAGE RETURN LATCH BAIL
IS LATCHED.
CLEARANCE BETWEEN LATCH BAIL AND
CARRIAGE RETURN LEVER,
MIN. 0.006 INCH- MAX. 0.035 INCH
(RIGHT SIDE VIEW)
ISS 8, SECTION 573-115-700TC
FEED PAWL
FEED PAWL RELEASE LINK
SPACING DRUM
(FRONT VIEW)
REQUIREMENT (UNITS EQUIPPED WITH TWO-
STOP FUNCTION CLUTCH)
SAME EXCEPT MAIN SHAFT SHOULD BE
ROTATED UNTIL FUNCTION CLUTCH IS
DISENGAGED IN STOP POSITION THAT
RESULTS IN LEAST CLEARANCE.
TO ADJUST
POSITION CARRIAGE RETURN LEVER ON
CARRIAGE RETURN BAIL WITH CLAMP
SCREW LOOSENED. TIGHTEN SCREW.
Page 45