Teletype 28 Manual page 148

SECTION 573-115-700TC
4. 26 Horizontal Tabulator Mechanism {Cont.)
(C)
HORIZONTAL TABULATOR SLIDE
ARM SPRING
OPERATING LEVER CAM ARM SPRING
HORIZONTAL TABULATOR SLIDE ARM SPRING
REQUIREMENT
HORIZONTAL TABULATOR SLIDE ARM
OPERATING LEVER IN
OPERATED POSITION.
SLIDE ARM IN UNOP-
ERATED POSITION.
MIN. 1 OZ.
MAX. 4 OZS.
TO START SLIDE ARM MOVING.
STRIPPER BAIL ARM SCREW
•HI.h
CAM ARM FOLLOWER
BAIL-----~
(D)
OPERATING LEVER CAM
PLATE SPRING
REQUIREMENT
(A)
OPERATING LEVER IN UNOPERATED
POSITION. HORIZONTAL TABULATOR
FUNCTION PAWL UNLATCHED.
MIN. 4 OZS.
MAX. 9 OZS.
TO START STRIPPER BAIL ARM MOVING.
CAM PLATE STRIPPER
BAIL------~
REQUIREMENT
OPE RAT lNG LEVER AND TABULATOR SLIDE
ARM IN UNOPERATED POSITIONS. SPACING
CLUTCH ROTATED UNTIL HIGH PART OF
SPACING CAM IS Of-POSITE CAM ARM
FOLLOWER BAIL CLEARANCE
MIN. 0.010 INCH
MAX. 0.025 INCH
TO ADJUST
POSITION STRIPPER BAIL ARM ON CA/IA ARM
FOLLOWER BAIL WITH STRIPPER BAIL ARM
SCREW FRICTION TIGHT. TIGHTEN SCREW.
?age 148
OPERATING LEVER
OPE RAT lNG LEVER CAM ARM
SPACING CA/IA
STRIPPER BAIL ARM
(LEFT SIDE VIEW)
TRANSFER BAIL EXTENSION ARM
SPACING CUTOUT TRANSFER BAIL
(B)
ADJUSTING SCREW
(BOTTOM VIEW)
' - - - - - - - - SPACING CUTOUT TRANSFER BAIL
SET COLLAR
REQUIREMENT
TRANSFER BAIL SHOULD
HAVE SOME END PLAY.
MAX. 0.008 INCH.
TO ADJUST
POSITION SET COLLAR
WITH ADJUSTING SCREW
LOOSENED. TIGHTEN
SCREW.
•
•