Teletype 28 Manual page 48

SECTION 573-115-700TC
2. 44 Spacing Mechanism (Cont.)
NOTE: CHECK RELATED ADJUSTMENTS, PARS. 2.30, 2.43 AND 2.47 IF THE FOLLOWING
ADJUSTMENTS ARE REMADE.
SPACING CUT-OUT TRANSFER BAIL
FEED PAWL
MOUNTING SCREWS.
SPACE SUPPRESSION RING
SPACING CUTOUT TRANSFER BAIL SPRING
REQUIREMENT
MIN. 1 OZ.
MAX. 3-1/2 OZS.
TO START BAIL MOVING.
Page 48
RIGHT MARGIN
REQUIREMENT
TYPE BOX CLUTCH DISENGAGED. CARRIAG·E IN
POSITION TO PRINT CHARACTER ON WHICH
SPACING CUTOUT IS TO OCCUR. FRONT FEED
PAWL FARTHEST ADVANCED. SPACING CUTOUT
TRANSFER BAIL HELD IN ITS UPPERMOST POSITION.
ON UNITS HAVING TWO PIECE SPACING CUTOUT
BAIL PUSH THE CUTOUT BAIL TOWARDS REAR OF
UNIT THROUGH HOLE IN FRONT PLATE. CLEAR-
ANCE BETWEEN EXTENSION ON SPACE SUPPRES-
SION RING AND TRANSFER BAIL
MIN. 0.006 INCH
-MAX~
0.025 INCH
TO ADJUST
POSITION SPACE SUPPRESSION RING WITH FOUR
INDICATED MOUNTING SCREWS LOOSENED.
TIGHTEN SCREWS.
NOTE
(1)
RANGE OF ADJUSTMENT IS FROM
0
TO
85
CHAR-
ACTERS.
(2) ON UNITS EQUIPPED WITH AUTOMATIC CARRIAGE
RETURN -LINE FEED RING, THIS ADJUSTMENT IS
NOT APPLICABLE. (SEE PAR. 2. 62)
(FRONT VIEW)
NOTE: FOR EARLIER DESIGN SEE PAR. 4.13