Teletype 28 Manual page 142

SECTION 573-115-700TC
4. 20 Line Feed Mechanism and Platen Mechanism
NOTE: THIS ADJUSTMENT APPLIES ONLY TO UNITS 'M TH A TWO-STOP FUNCTION CLUTCH
SINGLE-DOUBLE LINE FEED LEVER
REQUIREMENT
SINGLE-DOUBLE LINE FEED LEVER
LINE FEED FUNCTION PAWL
SINGLE ... DOUBLE LINE FEED LEVER IN SINGLE LINE FEED
POSITION. LINE FEED COMBINATION SET UP. MAIN SHAFT
ROTATED UNTIL THE LINE FEED FUNCTION PAWL STRIPPER
IS IN CONTACT WITH THE LINE FEED FUNCTION PAWL, THE
PAWL SHOULD OVERLAP THE STRIPPER BY
MIN. 1/2 THE PAWL THICKNESS
WHEN THE PLAY IN THE PAWL IS TAKEN UP IN A DIRECTION
TO MAKE THE OVERLAP MINIMUM.
TO ADJUST
POSITION THE LEVER ADJUSTING SCREW
TIGHTEN SCREW.
~-----...
(REAR VIEW)
LINE FEED
FUNCTION PAWL STRIPPER
Page 142
ADJUSTING SCREW
STRIPPER BLADE
•