Teletype 28 Manual page 101

ISS 8, SECTION 573-115-700TC
3.25
Continuous Spacing Mechanism (Cont.)
SLIDE ARM BRACKET
(TOP VIEW)
CARRIAGE RETURN SLIDE ARM
GUIDE BAR
SET BAIL OPERATING SPRING
REQUIREMENT
SUPPRESSION BAIL ADJUSTING BRACKET
REQUIREMENT .
FUNCTION CLUTCH ROTATED UNTIL SUPPRESSION BAIL
IS IN EXTREME FORWARD POSITION. CR AND LF
FUNCTION SLIDE ARMS MANUALLY PUSHED
FORWARD UNTIL THE CR AND LF LEVERS ARE TRIPPED.
SliDE ARMS RESTING BACK AGAINST THEIR SLIDE
ARM BRACKETS. CLEARANCE BETWEEN PROJECTION
ON CR SLIDE ARM AND GUIDE BAR
MIN. 0.070 INCH ---MAX. 0.095 INCH
TO ADJUST
POSITION THE CONNECTING LINK ON THE ADJUSTING
BRACKET WITH ITS CLAMP SCREW LOOSENED.
RECHECK AFTER TIGHTENING SCREW. ON TWO-STOP
CLUTCHES, CHECK WITH CLUTCH IN EACH POSITION.
NOTE
BEFORE MAKING THE FOLLOWING ADJUSTMENT CHECK
THE CARRIAGE RETURN LEVER ADJUSTMENT. WITH THE
STUNT BOX REMOVED, THE STANDARD ADJUSTING
PROCEDURE CANNOT BE FOLLOWED. REFER TO
PAR. 2.40 AND USE THE FOLLOWING PROCEDURE.
CARRIAGE RETURN LEVER
~EQUIREMENT
CLEARANCE BETWEEN CARRIAGE RETURN LATCH
BAIL AND CARRIAGE RETURN LEVER (PAR. 2.40)
SHOULD BE
FUNCTION RESET BAIL lN FORWARD POSITION
MIN. 2-1/4lBS.---MAX. 3-1/2 LBS.
MIN. 0.006 INCH---MAX. 0.040 INCH
TO CHECK
PRINTING CARRIAGE IN RETURNED POSITION. TRIP
FUNCTION CLUTCH AND ROTATE MAIN SHAFT
UNTil SUPPRESSION BAIL IS IN EXTREME FORWARD
POSITION. LOCATE SPACING DRUM SO THAT
CARRIAGE RETURN LATCH BAIL RESETS AGAINST
CARRIAGE RETURN LEVER EXTENSION.
TO START BAIL MOVING.
TO ADJUST
POSITION CR LEVER ON CR LATCH BAIL WITH
CLAMP SCREW LOOSENED. TIGHTEN SCREW •
. . , . . . . th
CONNECTING LINK
RESET BAIL
LINE FEED TRIP LEVER
(LEFT SIDE VIEW)
Page
101