Teletype 28 Manual page 111

ISS 8, SECTION 573-115·700TC
3. 35 Universal Contact (Stunt Box) Mechanism {continued)
LATCH LEVER
LATCH LEVER SPRING
REQUIREMENT
(REAR RIGHT
VIEW)
WITH LATCH LEVER RESTING ON HIGH PART
OF TRIP CAM
MIN 1/20Z
MAX 2 OZ
TO MOVE LATCH LEVER AWAY FROM TRIP CAM.
TRIP CAM
REQUIREMENT
WITH STRIPPER BAIL SHAFT DRIVE LINK
AT ITS LOWEST POINT, THE CLEARANCE
BETWEEN THE LATCH LEVER AND THE LATCH
CAM SHOULD BE
MIN 0.003 INCH
TO ADJUST
ROTATE THE TRIP CAM WITH ITS MOUNTING
SCREW LOOSENED. TIGHTEN SCREW.
NOTE: AS A CHECK TO SEE THAT THE TRIP CAM IS
NOT INSTALLED 180° OUT OF PLACE, THE MAIN
'S'FiAf=T SHOULD BE ROTATED SO THAT THE STRIPPER
SHAFT DRIVE LINK MOVES DOWNWARD.
·STRIPPER BAIL SHAFT
LATCH LEVER SPRING
Page 111