Teletype 28 Manual page 100

SECTION 573-115-700TC
3. 24 Continuous Spacing Mechanism
SOLENOID PLUNGER SPRING
REQUIREMENT
SOLENOID DE-ENERGIZED, SPRING UNHOOKED
MIN. 1-1/2 OZS.
MAX. 3 OZS.
TO PULL SPRING TO POSITION LENGTH.
PLUNGER SPRING
FUNCTION CLUTCH TRIP LEVER
(LEFT SIDE VIEW)
FUNCTION CLUTCH TRIP LEVER
REQUIREMENT
WITH THE SOLENOID DE-ENERGIZED AND
THE FUNCTION CLUTCH DISENGAGED, THE
FUNCTION CLUTCH TRIP LEVER SHOULD EN-
GAGE THE CLUTCH SHOE LEVER BY THE FULL
THICKNESS OF THE SHOE LEVER (CHECK AT
LUG WITH LEAST BITE ON TWO STOP
CLUTCHES).
TO ADJUST
POSITION THE SOLENOID MOUNTING PLATE
WITH ITS MOUNTING SCREWS LOOSENED.
TIGHTEN SCREWS. IN POSITIONING THE
PLATE MOVE EACH END EQUALLY TO AVOID
BINDS IN THE SOLENOID PLUNGER AND
FUNCTION CLUTCH TRIP LEVER.
Page 100
·~~
SOLENOID
0 0
SOLENOID MOUNTING PLATE
CLUTCH SHOE LEVER