Teletype 28 Manual page 34

SECTION 573-115-700TC
2. 29 Positioning Mechanism (Cont.)
VERTICAL POSITIONING LOCK LEVER
SPRING
REQUIREMENT
TYPE BOX CLUTCH DISENGAGED
MIN. 5 OZS.
MAX. 8 OZS.
TO START LOCK LEVER MOVING.
CHECK RIGHT ANO LEFT SPRINGS.
LEFT VERTICAL POSITIONING LOCK LEVER
VERTICAL
POSITIONING
L3 ) -
hOCK LEVER
SPRING
>7
§.
COMMON CODE BAR
ECCENTRIC STUD
ROCKER SHAFT LEFT BRACKET
(LEFT SIDE VIEW)
Page 34
VERTICAL POSITIONING
LEVER TOE
LEFT VERTICAL POSITIONING
LEVER ECCENTRIC STUD
REQUIREMENT
RIGHT AND LEFT VERTICAL
POSITIONING LEVERS SHOULD
BUCKLE EQUALLY WITHIN
0.006 INCH
TO CHECK
COMMON CODE BAR IN SPACING
POSITION. TRIP TYPE BOX
CLUTCH. ROTATE MAIN
SHAFT UNTIL RIGHT VER-
TICAL POSITIONING LEVER TOE
TOUCHES COMMON CODE BAR,
BUCKLING ITS LOWER LINK
0.008 INCH (MAXIMUM)
LEFT VERTICAL POSITIONING
LEVER TOE SHOULD TOUCH
COMMON CODE BAR, BUCKLING
ITS LOWER LINK EQUALLY
WITHIN 0.006 INCH
TO ADJUST
POSITION ECCENTRIC STUD
ON ROCKER SHAFT LEFT
BRACKET INNER ARM, POSI-
TION HIGH PART OF CAM
(MARKED WITH DOT) TOWARD
REAR. TIGHTEN NUT.