Teletype 28 Manual page 137

ISS 8, SECTION 573-115-700TC
4. 13 Spacing :i\Icchanism (Cont.)
NOTE: CHECK RELATED ADJUSTMENTS, PARS. 4.07, 2.38 AND 2.47, IF THE FOLLOWING
ADJUSTMENT ARE REMADE.
SPACING CUTOUT
TRANSFER BAIL
RIGHT MARGIN
REQUIREMENT (OPERATING ON BASE)
TYPE BOX CARRIAGE IN POSITION
TO PRINT CHARACTER ON WHICH
SPACING CUTOUT IS DESIRED.
FRONT SPACING PAWL FARTHEST
ADVANCED. CLEARANCE BETWEEN
UPPER EDGE OF SPACING CUTOUT
LEVER AND CUTOUT TRANSFER
BAIL WHEN SPACING CUTOUT
TRANSFER BAIL IS HELD IN ITS
EXTREME UPPER POSITION
MIN. 0.006 INCH---MAX. 0.025 INCH
TO ADJUST
POSITION THE CUTOUT LEVER WITH
ITS CLAMP SCREW LOOSENED.
TIGHTEN SCREW.
SPACING CUTOUT LEVER
SPACING CUTOUT TRANSFER BAIL SPRING
REQUIREMENT
MIN. 1 OZ. ---M.AX. 3-1/2 OZS.
TO START BAIL MOVING.
(FRONT VIEW)
.---------DECElERATING SliDE
_ _ _ DECELERATING SliDE BEll CRANK
(PART OF DECELERATING SliDE)
DECELERATING SliDE BELL CRANK
SPRING
REQUIREMENT
DECELERATING SLIDE BELl CRANK SPRING
MIN. 3/4 OZ.---MAX. 1-3/4 OZS.
TO START BELL CRANK MOVING.
CHECK RIGHT AND LEFT SPRINGS.
(FRONT VIEW)
Page 137