Teletype 28 Manual page 24

SECTION 573·115-700TC
2. 18 Main Shaft and Trip Shaft Mechanisms (Cont.)
CLUTCH TRIP LEVER
Il l
~
:.!:.,
(REAR VIEW)
FUNCTION CLUTCH
' i CLUTCH SHOE LEVER
(LEFT SIDE VIEW)
' - - - - - - - - - - F U N C T I O N CLUTCH TRIP LEVER
Page 24
(RIGHT SIDE VIE'N)
REQUIREMENT
CAM FOLLOWER ROLLER ON THE LOW
PART OF CAM.
THE SPRING UNHOOKED FROM SPRING
BRACKET.
MIN. 20 OZS.
MAX. 24 OZS.
TO PULL SPRING TO INSTALLED LENGTH.
REQUIREMENT
CODE BAR CLUTCH AND FUNCTION
CLUTCH DISENGAGED. FUNCTION
CLUTCH TRIP LEVER SHOULD
ENGAGE CLUTCH SHOE LEVER
BY FULL THICKNESS OF SHOE
LEVER. (CHECK AT LUG WITH
LEAST BITE ON TWO STOP
CLUTCHES).
TO ADJUST
POSITION TRIP LEVER ON ITS
SHAFT WITH CLAMP SCREW
LOOSENED, LETTING SHAFT
HAVE END PLAY. TIGHTEN SCREW.
MIN. SOME
MAX.
0.006
INCH
CODE BAR CLUTCH CAM